Abstract:
This project describes the design of solar powered charging station for charging of electric vehicle describes design of solar powered charging station for charging of electric vehicle that solves the key downside of fuel and pollution.
Electric vehicles have now hit the road worldwide and are slowly growing in numbers.
Apart from environmental benefits electric vehicles have also proven helpful in reducing cost of travel by replacing fuel by electricity which is way cheaper.
Well here we develop an EV charging system that solves with a unique innovative solution.
This EV charging of vehicles without any wires, No need of stop for charging, vehicle charges while moving, Solar power for keeping the charging system going, No external power supply needed.
The system makes use of a solar panel, battery, transformer, regulator circuitry, copper coils, AC to DC converter, Atmega controller and LCD display to develop the system.
The system demonstrates how electric vehicles can be charged while moving on the road, eliminating the need to stop for charging.
Thus the system demonstrates a solar powered wireless charging system for electric vehicles that can be integrated in the road.
This EV charging of vehicles without any wires, No need of stop for charging, vehicle charges while moving, Solar power for keeping the charging system going, No external power supply needed.
The system makes use of a solar panel, battery, transformer, regulator circuitry, copper coils, AC to DC converter, Atmega controller and LCD display to develop the system.
• Demo Video
• Complete project
• Full project report
• Source code
• Complete project support by online
• Life time access
• Execution Guidelines
• Immediate (Download)
Software Requirements:
• Arduino IDE
• Embedded C
Hardware Requirements:
• PWM IC, TL494 -1
• Buffer IC CD 4050 -1
• Bridge Rectifier – DB 107 – 3
• Capacitor 1000µF, 25V – 5
• Ac capacitor 0.1 µF – 2
• 0.01 µF ceramic capacitor – 1
• 0.1 µF ceramic capacitor - 1
• Transformer 230/12V, 750mA – 1
• 100Ω resistor -3
• 1KΩ resistor – 1
• TLP 250 Driver IC -1
• Not gate IC 7404 – 1
• IC base 8 pin -2
• IC base 16 pin -3
• Mosfet IRF 250 -2
• Mosfet Heat sink -2
• Circuit Board -1
• Enameled copper wire 0.5mm – 10m
• Enameled copper wire 0.23mm – 2m
• LED 5W -1
• Power chord -1
• Connecting wires (multi stand)
• Three wheel robot complete set (chassis , motors wheels)
• Voltage sensor 0-24v/0-12v (dc) -1
• I2C LCD with module -1
• Solar panel 0-24v (10w) -1
Immediate Download:
1. Synopsis
2. Rough Report
3. Software code
4. Technical support
Hardware Kit Delivery:
1. Hardware kit will deliver 4-10 working days (based on state and city)
2. Packing and shipping changes applicable (based on kit size, state ,city)
Only logged-in users can leave a review.